York YK Fault Code EE

EE
BAS communication fault
Warning
SAFETY WARNING: Commercial chillers contain high-pressure refrigerants and high-voltage electrical components (208V-4160V). Only EPA Section 608 certified technicians should perform diagnostic work. Always follow lockout/tagout procedures and wear appropriate PPE. Do not attempt repairs without proper training and equipment.
AI Summary

York YK Fault Code EE is a warning alarm indicating: BAS communication fault. The most common causes include Network cable fault. Estimated repair time: 30-90 minutes (requires network diagnostics and cable/connector inspection). This alarm requires immediate attention by a certified HVAC technician.

Alarm Description

BAS communication fault

Brand: York  |  Model: YK (Centrifugal Chiller (Water-Cooled))  |  Code: EE  |  Severity: Warning

Observable Symptoms

  • Controller display shows communication error or blank screen
  • BAS/EMS system shows chiller as offline or in alarm state

What to Check First

Before diving into detailed diagnostics, start with this quick first check:

Quick Start: Check cable

Probable Causes

  • Network cable fault
  • Controller offline
  • Protocol mismatch

Recommended Inspection Steps

  1. Check cable
  2. Verify controller
  3. Confirm protocol

Required Tools & Equipment

  • Safety PPE (gloves, safety glasses, face shield)
  • Wire tracing and continuity tester

Estimated Repair Time

30-90 minutes (requires network diagnostics and cable/connector inspection)

When to Call a Professional

  • If the fault persists after completing all recommended inspection steps
  • If you observe unusual noises, vibrations, or oil leaks from the compressor
  • If refrigerant charge levels are outside OEM specifications and EPA-certified recovery is needed
  • If electrical measurements show voltage imbalance greater than 2% between phases
  • If the fault recurs immediately after reset, indicating an unresolved safety condition
  • Contact an authorized York service representative for warranty-covered repairs

Related Fault Codes

Other York YK codes that may be related:

E1E2E3E4E5

OEM Service Manual Reference

OEM Reference: York YK Centrifugal Chiller Service Manual (Form 160.60-S1). Johnson Controls Technical Literature.

Frequently Asked Questions

What does York YK fault code EE mean?

Fault code EE on a York YK chiller indicates: BAS communication fault. This is a warning alarm that requires diagnostic attention.

What causes York YK alarm code EE?

Common causes include: Network cable fault; Controller offline; Protocol mismatch

How do I fix York YK error code EE?

Follow the recommended inspection steps below. Start with the quick check, then proceed through each step. If the fault persists after all steps, contact an authorized York service representative.

Disclaimer: All lookup data is for reference only. Do not use this information to replace certified professional HVAC technician judgment. Always refer to original OEM official service manual for York YK service procedures.