York YK Fault Code E13
York YK Fault Code E13 is a warning alarm indicating: Variable geometry inlet fault. The most common causes include Inlet guide vane actuator failure. Estimated repair time: 30-60 minutes (requires sensor replacement and calibration verification). This alarm requires immediate attention by a certified HVAC technician.
Alarm Description
Variable geometry inlet fault
Brand: York | Model: YK (Centrifugal Chiller (Water-Cooled)) | Code: E13 | Severity: Warning
Observable Symptoms
- Controller displays alarm code and description
- Chiller may be locked out or running in degraded mode
- Alarm indicator light is illuminated on control panel
What to Check First
Before diving into detailed diagnostics, start with this quick first check:
Probable Causes
- Inlet guide vane actuator failure
- Position sensor fault
- Mechanical binding of guide vanes
Recommended Inspection Steps
- Check actuator motor
- Verify position sensor
- Inspect linkage
- Replace actuator or sensor
Required Tools & Equipment
- Digital multimeter
- OEM service manual
- Safety PPE (gloves, safety glasses)
- Safety PPE (gloves, safety glasses, face shield)
Estimated Repair Time
30-60 minutes (requires sensor replacement and calibration verification)
When to Call a Professional
- If the fault persists after completing all recommended inspection steps
- If you observe unusual noises, vibrations, or oil leaks from the compressor
- If refrigerant charge levels are outside OEM specifications and EPA-certified recovery is needed
- If electrical measurements show voltage imbalance greater than 2% between phases
- If the fault recurs immediately after reset, indicating an unresolved safety condition
- Contact an authorized York service representative for warranty-covered repairs
Related Fault Codes
Other York YK codes that may be related:
OEM Service Manual Reference
OEM Reference: York YK Centrifugal Chiller Service Manual (Form 160.60-S1). Johnson Controls Technical Literature.
Frequently Asked Questions
What does York YK fault code E13 mean?
Fault code E13 on a York YK chiller indicates: Variable geometry inlet fault. This is a warning alarm that requires diagnostic attention.
What causes York YK alarm code E13?
Common causes include: Inlet guide vane actuator failure; Position sensor fault; Mechanical binding of guide vanes
How do I fix York YK error code E13?
Follow the recommended inspection steps below. Start with the quick check, then proceed through each step. If the fault persists after all steps, contact an authorized York service representative.