York YK Fault Code E10
York YK Fault Code E10 is a warning alarm indicating: Compressor motor bearing temperature high. The most common causes include Bearing lubrication inadequate. Estimated repair time: 1-2 hours. This alarm requires immediate attention by a certified HVAC technician.
Alarm Description
Compressor motor bearing temperature high
Brand: York | Model: YK (Centrifugal Chiller (Water-Cooled)) | Code: E10 | Severity: Warning
Observable Symptoms
- Controller displays alarm code and description
- Chiller may be locked out or running in degraded mode
- Alarm indicator light is illuminated on control panel
What to Check First
Before diving into detailed diagnostics, start with this quick first check:
Probable Causes
- Bearing lubrication inadequate
- Bearing wear
- Cooling oil flow insufficient
- Excessive vibration
Recommended Inspection Steps
- Check bearing temp sensors
- Verify oil circulation
- Measure vibration
- Inspect bearings
Required Tools & Equipment
- Infrared thermometer or calibrated temperature probe
- Oil level sight glass inspection tool
- Safety PPE (gloves, safety glasses, face shield)
Estimated Repair Time
1-2 hours
When to Call a Professional
- If the fault persists after completing all recommended inspection steps
- If you observe unusual noises, vibrations, or oil leaks from the compressor
- If refrigerant charge levels are outside OEM specifications and EPA-certified recovery is needed
- If electrical measurements show voltage imbalance greater than 2% between phases
- If the fault recurs immediately after reset, indicating an unresolved safety condition
- Contact an authorized York service representative for warranty-covered repairs
Related Fault Codes
Other York YK codes that may be related:
OEM Service Manual Reference
OEM Reference: York YK Centrifugal Chiller Service Manual (Form 160.60-S1). Johnson Controls Technical Literature.
Frequently Asked Questions
What does York YK fault code E10 mean?
Fault code E10 on a York YK chiller indicates: Compressor motor bearing temperature high. This is a warning alarm that requires diagnostic attention.
What causes York YK alarm code E10?
Common causes include: Bearing lubrication inadequate; Bearing wear; Cooling oil flow insufficient
How do I fix York YK error code E10?
Follow the recommended inspection steps below. Start with the quick check, then proceed through each step. If the fault persists after all steps, contact an authorized York service representative.