McQuay WMC Fault Code E06
McQuay WMC Fault Code E06 is a warning alarm indicating: Condenser water flow fault. The most common causes include Condenser water pump stopped. Estimated repair time: 4-6 hours (requires isolating water circuit, mechanical or chemical tube cleaning). This alarm requires immediate attention by a certified HVAC technician.
Alarm Description
Condenser water flow fault
Brand: McQuay | Model: WMC (Water-Cooled Screw Chiller) | Code: E06 | Severity: Warning
Observable Symptoms
- Water flow indicator shows zero or low flow
- Differential pressure across evaporator or condenser is low
- Pump may not be running or making abnormal noise
What to Check First
Before diving into detailed diagnostics, start with this quick first check:
Probable Causes
- Condenser water pump stopped
- Flow switch malfunction
- Condenser tubes fouled restricting flow
Recommended Inspection Steps
- Verify condenser water pump operation
- Check condenser flow switch
- Inspect and clean condenser tubes
- Verify proper water treatment
Required Tools & Equipment
- Coil cleaning brush and coil cleaner
- Safety PPE (gloves, safety glasses, face shield)
Estimated Repair Time
4-6 hours (requires isolating water circuit, mechanical or chemical tube cleaning)
When to Call a Professional
- If the fault persists after completing all recommended inspection steps
- If you observe unusual noises, vibrations, or oil leaks from the compressor
- If refrigerant charge levels are outside OEM specifications and EPA-certified recovery is needed
- If electrical measurements show voltage imbalance greater than 2% between phases
- If the fault recurs immediately after reset, indicating an unresolved safety condition
- Contact an authorized McQuay service representative for warranty-covered repairs
Related Fault Codes
Other McQuay WMC codes that may be related:
OEM Service Manual Reference
OEM Reference: McQuay WMC Water-Cooled Screw Chiller Service Manual. Available through Daikin Applied (formerly McQuay) technical support.
Frequently Asked Questions
What does McQuay WMC fault code E06 mean?
Fault code E06 on a McQuay WMC chiller indicates: Condenser water flow fault. This is a warning alarm that requires diagnostic attention.
What causes McQuay WMC alarm code E06?
Common causes include: Condenser water pump stopped; Flow switch malfunction; Condenser tubes fouled restricting flow
How do I fix McQuay WMC error code E06?
Follow the recommended inspection steps below. Start with the quick check, then proceed through each step. If the fault persists after all steps, contact an authorized McQuay service representative.