Lennox TCS Fault Code E16

E16
Fan motor fault
Warning
SAFETY WARNING: Commercial chillers contain high-pressure refrigerants and high-voltage electrical components (208V-4160V). Only EPA Section 608 certified technicians should perform diagnostic work. Always follow lockout/tagout procedures and wear appropriate PPE. Do not attempt repairs without proper training and equipment.
AI Summary

Lennox TCS Fault Code E16 is a warning alarm indicating: Fan motor fault. The most common causes include Fan motor winding failure. Estimated repair time: 1-2 hours. This alarm requires immediate attention by a certified HVAC technician.

Alarm Description

Fan motor fault

Brand: Lennox  |  Model: TCS (Water-Cooled Screw Chiller)  |  Code: E16  |  Severity: Warning

Observable Symptoms

  • Controller displays alarm code and description
  • Chiller may be locked out or running in degraded mode
  • Alarm indicator light is illuminated on control panel

What to Check First

Before diving into detailed diagnostics, start with this quick first check:

Quick Start: Check winding resistance

Probable Causes

  • Fan motor winding failure
  • Capacitor defective
  • Control relay fault

Recommended Inspection Steps

  1. Check winding resistance
  2. Test capacitor
  3. Verify relay operation
  4. Replace motor if faulty

Required Tools & Equipment

  • Digital multimeter
  • Safety PPE (gloves, safety glasses, face shield)

Estimated Repair Time

1-2 hours

When to Call a Professional

  • If the fault persists after completing all recommended inspection steps
  • If you observe unusual noises, vibrations, or oil leaks from the compressor
  • If refrigerant charge levels are outside OEM specifications and EPA-certified recovery is needed
  • If electrical measurements show voltage imbalance greater than 2% between phases
  • If the fault recurs immediately after reset, indicating an unresolved safety condition
  • Contact an authorized Lennox service representative for warranty-covered repairs

Related Fault Codes

Other Lennox TCS codes that may be related:

E01E02E03E04E05

OEM Service Manual Reference

OEM Reference: Lennox TCS Water-Cooled Screw Chiller Service Manual. Available through Lennox Commercial technical support.

Frequently Asked Questions

What does Lennox TCS fault code E16 mean?

Fault code E16 on a Lennox TCS chiller indicates: Fan motor fault. This is a warning alarm that requires diagnostic attention.

What causes Lennox TCS alarm code E16?

Common causes include: Fan motor winding failure; Capacitor defective; Control relay fault

How do I fix Lennox TCS error code E16?

Follow the recommended inspection steps below. Start with the quick check, then proceed through each step. If the fault persists after all steps, contact an authorized Lennox service representative.

Disclaimer: All lookup data is for reference only. Do not use this information to replace certified professional HVAC technician judgment. Always refer to original OEM official service manual for Lennox TCS service procedures.