Lennox SCA Fault Code E01
Lennox SCA Fault Code E01 is a warning alarm indicating: Supply air temperature sensor fault. The most common causes include Sensor element failure. Estimated repair time: 30-60 minutes (requires sensor replacement and calibration verification). This alarm requires immediate attention by a certified HVAC technician.
Alarm Description
Supply air temperature sensor fault
Brand: Lennox | Model: SCA (Air-Cooled Scroll Chiller) | Code: E01 | Severity: Warning
Observable Symptoms
- Temperature reading on controller display shows abnormal value or dashes
- Chiller may not start or cycles erratically due to incorrect temperature input
What to Check First
Before diving into detailed diagnostics, start with this quick first check:
Probable Causes
- Sensor element failure
- Sensor wiring open or shorted
- Control board input channel damaged
Recommended Inspection Steps
- Identify faulting sensor from diagnostic code
- Measure sensor resistance at known temperature
- Check wiring continuity from sensor to board
- Inspect connector pins for corrosion
- Replace sensor if out of specification
Required Tools & Equipment
- Digital multimeter
- Infrared thermometer or calibrated temperature probe
- Safety PPE (gloves, safety glasses, face shield)
- Wire tracing and continuity tester
Estimated Repair Time
30-60 minutes (requires sensor replacement and calibration verification)
When to Call a Professional
- If the fault persists after completing all recommended inspection steps
- If you observe unusual noises, vibrations, or oil leaks from the compressor
- If refrigerant charge levels are outside OEM specifications and EPA-certified recovery is needed
- If electrical measurements show voltage imbalance greater than 2% between phases
- If the fault recurs immediately after reset, indicating an unresolved safety condition
- Contact an authorized Lennox service representative for warranty-covered repairs
Related Fault Codes
Other Lennox SCA codes that may be related:
OEM Service Manual Reference
OEM Reference: Lennox SCA Air-Cooled Scroll Chiller Service Manual. Available through Lennox Commercial technical support.
Frequently Asked Questions
What does Lennox SCA fault code E01 mean?
Fault code E01 on a Lennox SCA chiller indicates: Supply air temperature sensor fault. This is a warning alarm that requires diagnostic attention.
What causes Lennox SCA alarm code E01?
Common causes include: Sensor element failure; Sensor wiring open or shorted; Control board input channel damaged
How do I fix Lennox SCA error code E01?
Follow the recommended inspection steps below. Start with the quick check, then proceed through each step. If the fault persists after all steps, contact an authorized Lennox service representative.