Carrier 30XA Fault Code 57

57
Low saturated suction temperature, circuit B
Warning
SAFETY WARNING: Commercial chillers contain high-pressure refrigerants and high-voltage electrical components (208V-4160V). Only EPA Section 608 certified technicians should perform diagnostic work. Always follow lockout/tagout procedures and wear appropriate PPE. Do not attempt repairs without proper training and equipment.
AI Summary

Carrier 30XA Fault Code 57 is a warning alarm indicating: Low saturated suction temperature, circuit B. The most common causes include Low refrigerant charge on circuit B. Estimated repair time: 2-4 hours (requires leak repair, evacuation, and refrigerant recharge). This alarm requires immediate attention by a certified HVAC technician.

Alarm Description

Low saturated suction temperature, circuit B

Brand: Carrier  |  Model: 30XA (Screw Compressor Chiller)  |  Code: 57  |  Severity: Warning

Observable Symptoms

  • Controller displays alarm code and description
  • Chiller may be locked out or running in degraded mode
  • Alarm indicator light is illuminated on control panel

What to Check First

Before diving into detailed diagnostics, start with this quick first check:

Quick Start: Check superheat and subcooling on circuit B

Probable Causes

  • Low refrigerant charge on circuit B
  • Expansion valve B starving evaporator
  • Evaporator water flow too low
  • Dirty or iced evaporator

Recommended Inspection Steps

  1. Check superheat and subcooling on circuit B
  2. Verify expansion valve B operation
  3. Measure evaporator water flow
  4. Add refrigerant if charge is low on circuit B

Required Tools & Equipment

  • Infrared thermometer or calibrated temperature probe
  • PT chart for refrigerant type
  • Safety PPE (gloves, safety glasses, face shield)

Estimated Repair Time

2-4 hours (requires leak repair, evacuation, and refrigerant recharge)

When to Call a Professional

  • If the fault persists after completing all recommended inspection steps
  • If you observe unusual noises, vibrations, or oil leaks from the compressor
  • If refrigerant charge levels are outside OEM specifications and EPA-certified recovery is needed
  • If electrical measurements show voltage imbalance greater than 2% between phases
  • If the fault recurs immediately after reset, indicating an unresolved safety condition
  • Contact an authorized Carrier service representative for warranty-covered repairs

Related Fault Codes

Other Carrier 30XA codes that may be related:

12379

OEM Service Manual Reference

OEM Reference: Carrier 30XA Service Manual (Form 30XA-6SI). Available through Carrier Commercial Systems technical support or partnered distributors.

Frequently Asked Questions

What does Carrier 30XA fault code 57 mean?

Fault code 57 on a Carrier 30XA chiller indicates: Low saturated suction temperature, circuit B. This is a warning alarm that requires diagnostic attention.

What causes Carrier 30XA alarm code 57?

Common causes include: Low refrigerant charge on circuit B; Expansion valve B starving evaporator; Evaporator water flow too low

How do I fix Carrier 30XA error code 57?

Follow the recommended inspection steps below. Start with the quick check, then proceed through each step. If the fault persists after all steps, contact an authorized Carrier service representative.

Disclaimer: All lookup data is for reference only. Do not use this information to replace certified professional HVAC technician judgment. Always refer to original OEM official service manual for Carrier 30XA service procedures.