Carrier 23XRV Fault Code 3

3
Condenser entering water temperature sensor fault
Warning
SAFETY WARNING: Commercial chillers contain high-pressure refrigerants and high-voltage electrical components (208V-4160V). Only EPA Section 608 certified technicians should perform diagnostic work. Always follow lockout/tagout procedures and wear appropriate PPE. Do not attempt repairs without proper training and equipment.
AI Summary

Carrier 23XRV Fault Code 3 is a warning alarm indicating: Condenser entering water temperature sensor fault. The most common causes include Sensor failure. Estimated repair time: 30-60 minutes (requires sensor replacement and calibration verification). This alarm requires immediate attention by a certified HVAC technician.

Alarm Description

Condenser entering water temperature sensor fault

Brand: Carrier  |  Model: 23XRV (Variable Speed Screw Chiller (AquaForce))  |  Code: 3  |  Severity: Warning

Observable Symptoms

  • Temperature reading on controller display shows abnormal value or dashes
  • Chiller may not start or cycles erratically due to incorrect temperature input

What to Check First

Before diving into detailed diagnostics, start with this quick first check:

Quick Start: Measure resistance

Probable Causes

  • Sensor failure
  • Wiring fault
  • Board input issue

Recommended Inspection Steps

  1. Measure resistance
  2. Check wiring
  3. Replace sensor

Required Tools & Equipment

  • Digital multimeter
  • Infrared thermometer or calibrated temperature probe
  • Safety PPE (gloves, safety glasses, face shield)
  • Wire tracing and continuity tester

Estimated Repair Time

30-60 minutes (requires sensor replacement and calibration verification)

When to Call a Professional

  • If the fault persists after completing all recommended inspection steps
  • If you observe unusual noises, vibrations, or oil leaks from the compressor
  • If refrigerant charge levels are outside OEM specifications and EPA-certified recovery is needed
  • If electrical measurements show voltage imbalance greater than 2% between phases
  • If the fault recurs immediately after reset, indicating an unresolved safety condition
  • Contact an authorized Carrier service representative for warranty-covered repairs

Related Fault Codes

Other Carrier 23XRV codes that may be related:

17144454

OEM Service Manual Reference

OEM Reference: Carrier 23XRV AquaForce Variable Speed Screw Chiller Service Manual. Available through Carrier Commercial Systems.

Frequently Asked Questions

What does Carrier 23XRV fault code 3 mean?

Fault code 3 on a Carrier 23XRV chiller indicates: Condenser entering water temperature sensor fault. This is a warning alarm that requires diagnostic attention.

What causes Carrier 23XRV alarm code 3?

Common causes include: Sensor failure; Wiring fault; Board input issue

How do I fix Carrier 23XRV error code 3?

Follow the recommended inspection steps below. Start with the quick check, then proceed through each step. If the fault persists after all steps, contact an authorized Carrier service representative.

Disclaimer: All lookup data is for reference only. Do not use this information to replace certified professional HVAC technician judgment. Always refer to original OEM official service manual for Carrier 23XRV service procedures.